TS5A3357QDCURQ1 Overview

The electronic part can be shipped overseas conveniently because it is packaged in 8-VFSOP (0.091, 2.30mm Width). Advanced packaging method Tape & Reel (TR) is used to provide high reliability. A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 3:1. Increasing operating temperature to around -40°C~125°C TA. A total of 8 terminations have been recorded. A 1 channel electronic part produces high-quality output. In the case of a voltage supply of 1.8V volts, the electrical part can be powered up and run. A total of 8 pins are injected into the body of the electronic part. These analog multiplexers are built based on SP3T switching circuits. Look for analog switch ic variants by searching with TS5A3357. Internally, this switch multiplexer has a resistance of 15Ohm. Datasheets for 8 pin functions are available upon request. It is a typical Multiplexer or Switches analog multiplexer. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. Analogue multiplexer with a Single supply type that is cost-effective. 1.65V should be the lowest voltage fed to the electronic component. For this digital switch to work, 1μA current would suffice. Draining from a single voltage supply, this analog switch requires a voltage of 1.65V~5.5V. When the digital multiplexer is charged above 10μA, damage can occur. In order to operate the 1 inputs, there are several steps to follow. The transfer of data can be performed over 334MHz bandwidths. There are 3 outputs on the analogue multiplexer. From the Automotive, AEC-Q100 series.

TS5A3357QDCURQ1 Features

1 Channels
Switch Circuit: SP3T
1μA Supply Current
Bandwidth: 334MHz

TS5A3357QDCURQ1 Applications

There are a lot of Texas Instruments TS5A3357QDCURQ1 Analog Switches & Multiplexers ICs applications.

• Mechanical reed relay replacement
• FTTH
• Industrial control systems
• PBX interfaces
• Isolation
• Video signal routing
• PBXs
• PDH Multiplexers
• SDH
• Transmit