As the electronic part is packed in 8-VFSOP (0.091, 2.30mm Width), international shipping is convenient. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). Surface Mount is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 3:1. Operating temperature around -40°C~85°C TA extended. Total terminations are 8. As a result of its 3 channels, this electronic component provides high-quality output. It is safe to turn on and run the electronic component with a 1.8V voltage supply. An electrical component like this is included in the 8 series. Based on SP3T switching circuits, these analog multiplexers work. Try searching with TS5A3359 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 900mOhm. For functions related to 8 pins, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. Analogue multiplexers of the Single supply type that are cost-effective. In order for the electronic part to function properly, the lowest voltage should be 1.65V. The switch device would be able to operate with 16nA current. An analogue multiplexer drains from a single voltage supply at 1.65V~5.5V. A digital multiplexer may suffer damage if voltage is applied above 50nA. The 1 inputs need to be operated in order to work. It is possible to transfer data over a 100MHz-bandwidth. There is 900mOhm resistance between Drain and Source for this electronic part. This digital multiplexer has 3 outputs.