As the electronic part is packed in 8-XFBGA, DSBGA, international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 8. The electronic part provides high-quality output because it has 1 channels. Powered by a 2.5V voltage supply, the electrical part should be switched on and run. The electrical component body receives 8 pins. Circuits based on SPDT switching are used to construct these analog switch ics. Try searching with TS5A6542 to find analog multiplexer variants. An switch multiplexer with 750mOhm internal resistance has a value of 750mOhm. Datasheets for 8 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 2.25V. An operating current of 5.5nA would be sufficient for this switch device. Using a single voltage supply, this switch device consumes 2.25V~5.5V volts. When the digital multiplexer is charged above 100nA, damage can occur. Operating the 1 inputs requires 1 inputs. There are 43MHz bandwidths for data transfer. It has a Drain to Source resistance of 800mOhm ohms. A analog switch ics with 2 outputs is included.