UCC28250RGPT Overview

It comes in a 20-VFQFN Exposed Pad package, so switching controller can be used for most applications. This dc motor controller can be used to generate outputs with 2 numbers. Tape & Reel (TR) is the solid enclosure in which PMIC is packaged. With PWM Signal dc switching's output (s), it is able to handle it. dc controls with 4.7V~17V voltage are supplied and operated. A -40°C~125°C TJ dc switcher is not a problem. A switching controller such as this can switch at a value of 85kHz~1.15MHz . It is suitable for general dc dc regulator when it is set to Surface Mount. DCDC regulator is controlled efficiently by Current Limit, Enable, Frequency Control, Ramp, Soft Start. Switch converters are connected to ICs with SWITCHING CONTROLLER analog outputs. Thare switching converters has a terminal (s) at QUAD . A variety of 20 terminations are available in dc switching. These dc dc converter ics adapt several control methods, including PULSE WIDTH MODULATION. DC switcher's input voltageis 12V volts. UCC28250 can be used to locate other relevant dc to dc converter ics. The switching converter has a total of 20 pins. Switching converter is a special type of Switching Regulator or Controllers. As determined by the test statistics, the output voltage of DC regulator is 3.38V. You should note down the dc dc regulator's usual output current of 20mA when you start a project. A duty cycle set at 100 % ensures voltage regulator dc to dc reliability during power-on and power-off. Switching controller operates at a frequency of 1MHz. If the user wishes to run the voltage regulator dc to dc in a circuit safely and reliably, they should apply 12V. You can set the input voltage to 17V for nominal working status. Voltage 12V is required for supply. It runs on a 2.7mA supply current. In the presence of a current greater than 3.4mA, the component may fail to operate properly and may be damaged.

UCC28250RGPT Features

PWM Signal Outputs
Switching Frequency: 85kHz~1.15MHz
Current Limit, Enable, Frequency Control, Ramp, Soft Start
PULSE WIDTH MODULATION
Max Duty Cycle: 100 %
Frequency: 1MHz

UCC28250RGPT Applications

There are a lot of Texas Instruments
UCC28250RGPT DC to DC converter applications.

• Computer application technology
• Network technology
• Automation technology
• CMM
• Various precision measuring instruments
• Various precision measuring detectors
• Flaw detection equipment
• Balance equipment
• Industrial robots
• Industrial controllers