DG302BDJ-E3 Overview

Shipping overseas is convenient with the electronic component packed in 14-DIP (0.300, 7.62mm). High reliability is provided by advanced packaging method Tube. In Through Hole, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 2:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 14. High-quality output is provided by the electronic component's 4 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. The electronic part body is injected with 14 pins. A DPST - NO switching circuit is used to build these analog multiplexers. There are 2 circuits in this multiplexer. Try searching with DG302 if you're looking for variants. There is 30Ohm internal resistance in this digital multiplexer. For functions related to 14 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 36V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. 13V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 230μA current would be sufficient. The analogue multiplexer may be damaged if voltage is greater than 1mA. If put voltage greater than 22V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 7V. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. 15V operating voltages are supported by the electronic component.

DG302BDJ-E3 Features

4 Channels
Switch Circuit: DPST - NO
230μA Supply Current

DG302BDJ-E3 Applications

There are a lot of Vishay Siliconix
DG302BDJ-E3 Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems