Shipping overseas is convenient due to the electrical component's packing in 14-DIP (0.300, 7.62mm). High reliability is ensured by the advanced packaging method Tube. A switch device like this is mounted in Through Hole. Multiplexers and demultiplexers have a number of circuits 2:1. Operational temperature extended around -40°C~85°C TA. Total terminations are 14. Powered by a 15V voltage supply, the electrical part should be switched on and run. 14 pins are injected to the electronic part body. DPST - NO/NC switching circuits are used in these analog switch ics. The circuits in this analogue multiplexer number 2. Analog switches have 50Ohm internal resistance. For functions related to 14 pins, please refer to the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 36V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. It is recommended to use 13V as the lowest voltage for the electrical part. The switch device would be able to operate with 230μA current. If put voltage greater than 1mA on the device, damage may be caused to the analogue multiplexer. For this multiplexer, dual supply voltage is feasible, but it should not exceed 22V. If you are using dual power supplies, you should attach at least 7V. It is integrated with SPST analog ICs. A voltage of 15V can be used to operate the electronic component. The electrical component supports 4 inputs. Resistivity from Drain to Source is 50Ohm for this electronic part.