This electronic part is conveniently packaged in 16-TSSOP (0.173, 4.40mm Width), making it easy to ship abroad. High reliability is provided by advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. Multiplexers and demultiplexers have the same number of circuits 1:1. Increasing operating temperature to around -40°C~85°C TA. The total number of terminations is 16. A electrical component with 1 channels is capable of high-quality output. When a voltage supply of 15V is used, the electronic component should be turned on and run. Into the electrical component body are injected 16 pins. A SPST - NC switching circuit is used to build these analog multiplexers. Circuits number 4 make up this analogue multiplexer. Try searching for the analog switch ic with DG309 if you are looking for variants. It has an internal resistance of 160Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. Users should never supply a voltage higher than 44V to a switch device. Dual, Single supply type digital switch with a low cost. The lowest voltage fed to the electronic component should be 4V. 1μA current would be enough for this multiplexer to operate. A voltage higher than 1μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 22VIf you are using a dual power supply, you should attach at least 4V. There are SEPARATE OUTPUT outputs on this analog switch ic.
DG309BDQ-T1-E3 Features
1 Channels Switch Circuit: SPST - NC 1μA Supply Current
DG309BDQ-T1-E3 Applications
There are a lot of Vishay Siliconix DG309BDQ-T1-E3 Analog Switches & Multiplexers ICs applications.
Audio/video switches
Digital Cross-Connects
Communication systems
Voice over IP/DSL – Integrated Access Devices, Smart