As the electronic part is packed in 20-SOIC (0.295, 7.50mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tube. The multiplexer is located in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 20. The electronic part provides high-quality output because it has 4 channels. Powered by a 15V voltage supply, the electrical part should be switched on and run. The electrical component body receives 20 pins. Circuits based on SPDT switching are used to construct these analog switch ics. There are 1 circuits in this switch device. Try searching with DG333 to find analog multiplexer variants. An switch multiplexer with 75Ohm internal resistance has a value of 75Ohm. Datasheets for 20 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 40V in normal situations. The analog switch ic is of the Dual, Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 5V. An operating current of 200μA would be sufficient for this switch device. When the digital multiplexer is charged above 200μA, damage can occur. Despite this switch device's dual supply capability, its voltage should not exceed 22V. It is recommended that you attach at least 4V to your dual power supply. It has a Drain to Source resistance of 25Ohm ohms. A analog switch ics with 8 outputs is included.