DG403DY-E3 Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-SOIC (0.154, 3.90mm Width). High reliability is achieved by using advanced packaging method Tube. Mounted in Surface Mount is this multiplexer. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature extended to -40°C~85°C TA. Totally, there are 16 terminations. High-quality output is provided by the electronic component's 1 channels. An 15V voltage supply should allow the electrical part to be turned on and run. As part of its design, the 16 series is equipped with this electronic component. SPST - NO/NC switching circuits are used in these analog switch ics. It consists of 2 circuits. Try searching for DG403 variants of the analog switch ic. There is 45Ohm internal resistance in this digital multiplexer. The functions of 16 pins can be found in the datasheets. Theswitch device is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 36V. Dual, Single supply type digital switch with a low cost. The lowest voltage the electronic part should receive is 13V. It would be sufficient to run this analogue multiplexer with 5μA current. A digital multiplexer may suffer damage if voltage is applied above 1μA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 22V. If you are using dual power supplies, you should attach at least 7V. This electrical part is compatible with 15V operating voltages. 4 outputs are included in the analogue multiplexer.

DG403DY-E3 Features

1 Channels
Switch Circuit: SPST - NO/NC
5μA Supply Current

DG403DY-E3 Applications

There are a lot of Vishay Siliconix DG403DY-E3 Analog Switches & Multiplexers ICs applications.

• Precision test equipment
• Cell phones
• Power routing
• Remote Powered Equipment
• Communication systems
• Signal routing between systems
• Precision data acquisition
• Communications systems
• PDAs
• Digital access cross connects