DG411LDY-E3 Overview

Shipping overseas is convenient with the electronic component packed in 16-SOIC (0.154, 3.90mm Width). High reliability is provided by advanced packaging method Tube. In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 1:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 16. High-quality output is provided by the electronic component's 1 channels. If the voltage supply is 5V volts, the electrical component should be turned on and run. The electronic part body is injected with 16 pins. A SPST - NC switching circuit is used to build these analog multiplexers. Try searching with DG411 if you're looking for variants. There is 33Ohm internal resistance in this digital multiplexer. For functions related to 16 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 12V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. 2.7V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 1μA current would be sufficient. The analogue multiplexer may be damaged if voltage is greater than 1μA. If put voltage greater than 6V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 3V. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. It is possible to operate 4 inputs. Drain to Source resistance is 30Ohm.

DG411LDY-E3 Features

1 Channels
Switch Circuit: SPST - NC
1μA Supply Current
-3db Bandwidth: 280MHz
Drain-to-Source resistance: 30Ohm

DG411LDY-E3 Applications

There are a lot of Vishay Siliconix
DG411LDY-E3 Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems