As the electronic part is packed in 8-DIP (0.300, 7.62mm), international shipping is convenient. High reliability is achieved by using advanced packaging method Tube. It is mounted in the position Through Hole. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. In total, 8 terminations have occurred. By its 1 channels, the electronic component provides high-quality output. Powered by a 15V voltage supply, the electrical part should be switched on and run. A total of 8 pins are injected into the body of the electronic part. Unlike digital switches, these are based on SPST - NC switching circuits. Search with DG417 if you are looking for analog multiplexer variants. This digital multiplexer has 35Ohm internal resistance. For details about the functions of 8 pins, please refer to the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. Users should never supply a voltage higher than 36V to a switch device. Analog switch ics with Dual, Single supply type are cost-effective. It is recommended that the electrical component receives a voltage of 13V. For this multiplexer to operate, 1nA current would be sufficient. If put voltage greater than 1μA on the device, damage may be caused to the analogue multiplexer. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 22V. With dual power supplies, you should attach at least 7V. The electrical part can be operated at 15V voltage levels. A 1 input needs to be operated. The Drain to Source resistance of this electronic component is 35Ohm.