DG417DY-T1-E3 Overview

Shipping overseas is convenient due to the electrical component's packing in 8-SOIC (0.154, 3.90mm Width). Advanced packaging method Tape & Reel (TR) is used to provide high reliability. Surface Mount is where this multiplexer is located. There is 1:1 ratio between the number of multiplexers and demultiplexers. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 8. High-quality output is provided by the electronic component's 1 channels. When the electronic component is given a voltage of 15V, it should be turned on and run. As part of its design, the 8 series is equipped with this electronic component. These analog multiplexers are built based on SPST - NC switching circuits. Try searching with DG417 to find analog multiplexer variants. An switch multiplexer with 40Ohm internal resistance has a value of 40Ohm. To find out what the functions of 8 pins are, please refer to their datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 36V volts for the multiplexer. A cost-effective Dual, Single supply type analogue multiplexer. 13V is the lowest voltage that should be fed to the electronic electronic part. An operating current of 1nA would be sufficient for this switch device. Putting voltage greater than 1μA on the multiplexer may cause damage. For this switch, a dual supply voltage is feasible, but it must not exceed 22VYou should attach at least 7V voltage if you are using dual power supply. The electrical component supports 1 inputs.

DG417DY-T1-E3 Features

1 Channels
Switch Circuit: SPST - NC
1nA Supply Current

DG417DY-T1-E3 Applications

There are a lot of Vishay Siliconix DG417DY-T1-E3 Analog Switches & Multiplexers ICs applications.

• SDH/SONET multiplexers
• T1/E1 Terminals
• Mechanical reed relay replacement
• Cable Telephony – NIU, Set-Top Box, Home Side Box
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• FTTH
• Imaging
• Automatic test equipment
• MP3 players
• New designs requiring multiplexer functions