Shipping overseas is convenient due to the electrical component's packing in 8-DIP (0.300, 7.62mm). Advanced packaging method Tube is used to provide high reliability. There is an analog multiplexer mounted in position Through Hole. Multiplexers and demultiplexers have the same number of circuits 2:1. Extended operating temperature around -40°C~85°C TA. The total number of terminations is 8. This electronic part offers high-quality output due to its 1 channels. Turning on and running the electrical part should be easy with a 15V voltage supply. A total of 8 pins are injected into the body of the electronic part. Multiplexers built on a SPDT switching circuit are built. Search with DG419 if you are looking for analog multiplexer variants. There is 35Ohm internal resistance in this digital multiplexer. For functions related to 8 pins, please refer to the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 36V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. 13V should be the lowest voltage fed to the electronic component. This multiplexer would work with 1nA current. Put voltage above 1μA on the multiplexer to cause damage. For this switch, a dual supply voltage is feasible, but it must not exceed 22VThe voltage should be at least 7V if you are using dual power supplies. 15V operating voltages are supported by the electronic component. It is possible to operate 1 inputs. The Drain to Source resistance of this electronic component is 35Ohm. The analog switch ics includes 2 outputs.