DG441LDQ-T1-E3 Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. Multiplexer and demultiplexer circuits have a number 1:1. Operating temperature around -40°C~85°C TA extended. A total of 16 terminations have been recorded. The electronic part delivers high-quality output through its 1 channels. When the electronic component is given a voltage of 5V, it should be turned on and run. This electronic part can be found in the 16 series. On the other hand, analog switches can be constructed using SPST - NC switching circuits. If you are looking for variants of the digital switch, trying search with DG441. The internal resistance of this digital multiplexer is 35Ohm. Datasheets for 16 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. A voltage higher than 12V should not normally be supplied to the switches. Analogue multiplexer with a Dual, Single supply type that is cost-effective. In order for the electronic part to function properly, the lowest voltage should be 2.7V. It would be sufficient to run this analogue multiplexer with 10μA current. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. If put voltage greater than 6V on the multiplexer, damage may be caused to the device. You should attach at least 3V voltage if you are using dual power supply. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. Operating the 4 inputs requires 4 inputs. It has a Drain to Source resistance of 17Ohm ohms.

DG441LDQ-T1-E3 Features

1 Channels
Switch Circuit: SPST - NC
10μA Supply Current
-3db Bandwidth: 280MHz
Drain-to-Source resistance: 17Ohm

DG441LDQ-T1-E3 Applications

There are a lot of Vishay Siliconix DG441LDQ-T1-E3 Analog Switches & Multiplexers ICs applications.

• SONET/SDH ADM
• Cable Telephony – NIU, Set-Top Box, Home Side Box
• Data switching
• Cable PC
• Channelized and Unchannelized DS3 applications
• Digital Cross-Connects
• Fiber In The Loop (FITL)
• DSUs
• Voice over IP/DSL – Integrated Access Devices, Smart
• Frame Relay Equipment