The electrical component comes in 16-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. High reliability is ensured by the advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a number of circuits 1:1. Increasing operating temperature to around -40°C~85°C TA. 16 terminations have been made so far. The electronic part provides high-quality output because it has 1 channels. With a 5V voltage supply, the electrical component should be turned on and run. It is injected into the electrical part body with 16 pins. Based on SPST - NC switching circuits, these analog multiplexers work. DG441 can be used to search for analog multiplexer variants. It has an internal resistance of 35Ohm. Datasheets for 16 pin functions are available upon request. A analogue multiplexer of this type is a Multiplexer or Switches. Multiplexers should not be powered above 12V in normal situations. Analogue multiplexer with a Dual, Single supply type that is cost-effective. It is recommended that the electrical component receives a voltage of 2.7V. This multiplexer would work with 10μA current. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. If put voltage greater than 6V on the multiplexer, damage may be caused to the device. It is recommended that you attach at least 3V to your dual power supply. There are SEPARATE OUTPUT outputs on this analog switch ic. The 4 inputs need to be operated in order to work.