Shipping overseas is convenient with the electronic component packed in 16-DIP (0.300, 7.62mm). The advanced packaging method Tube provides high reliability. The multiplexer is located in Through Hole. 1:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature around -40°C~85°C TA extended. In total, 16 terminations have occurred. High-quality output is provided by the electronic component's 1 channels. Powered by a 15V voltage supply, the electrical part should be switched on and run. As part of the design of the 16 series, this electronic part has been incorporated into the system. The analog switch ics are built using SPST - NC switching circuits. If you are looking for variants of the digital switch, trying search with DG444. As far as internal resistance is concerned, it has 160Ohm. For functions related to 16 pins, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. In a normalsituation, users should not supply the switches with voltage higher than 36V. Dual, Single supply type digital switch with a low cost. A low voltage of 13V should be applied to the electronic component. In order to operate this switch device, it would need a current of 5μA. Putting voltage greater than 1μA on the multiplexer may cause damage. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 22V. You should attach at least 7V voltage if you are using dual power supply. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. The 4 inputs need to be operated in order to work. This electronic component presents a Drain to Source resistance of 85Ohm.