AD623ANZ Overview

Op amp is packaged in 8-DIP (0.300, 7.62mm) case. A Instrumentation-type buffer amplifier is shown here. In the case of Tube cases, linear amplifier will be delivered. During the past two weeks, there have been close to 8 terminations. There are a total of 8 pins on this op amp. This linear amplifier should be powered by an 5V battery. The op amp ic has an array of 8 pins on it. Op amp rates 25μV as input offset voltage. Through Hole is the recommended mounting type for this linear amplifier. It is important to note that this linear amplifier works well at a temperature of -40°C~85°C when it comes to operating temperatureThis op amp can operate from a supply current at 550μA. The op amp ic has 1 channels on it. One of the advantages of this op amp is that it outputs Rail-to-Rail signals, which is one of its many advantages. The operating supply voltage of instrumentation amplifier is rated 9V voltage. To conduct electronic part voltage gain higher than 1. In order for the buffer amplifier resistance to remain within the 2GOhm range, the device should be tested.

AD623ANZ Features

8 Pins
supply voltage of 5V
Output Type: Rail-to-Rail
Resistance of 2GOhm

AD623ANZ Applications

There are a lot of Analog Devices Inc. AD623ANZ Instrumentational OP Amps applications.

• Tablets
• Measurements of Wheatstone bridge
• Broadcasting
• High input resistance broadband
• single/dual op amp sum and difference circuits
• Voltage regulation circuit
• Navigation
• Signal filtering
• Micro signal measurement
• Portable media players