The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). The advanced packaging method Tape & Reel (TR) provides high reliability. In Surface Mount, this analog switch is mounted. Multiplexer and demultiplexer circuits have a number 2:1. Operation at a temperature around -40°C~125°C TA. 16 terminations have been made so far. Due to its 2 channels, the electrical component produces high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. As part of the design of the 16 series, this electronic part has been incorporated into the system. These analog multiplexers are built based on SPDT switching circuits. ADG1236 can be used to search for analog multiplexer variants. An switch multiplexer with 190Ohm internal resistance has a value of 190Ohm. Datasheets for 16 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 16.5V volts for the multiplexer. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended that the electrical component receives a voltage of 5V. 170μA current would be enough for this multiplexer to operate. The analogue multiplexer may be damaged if voltage is greater than 230μA. If put voltage greater than 16.5V on the multiplexer, damage may be caused to the device. In the case of dual power supplies, you should connect at least 5V. A voltage of 12V can be used to operate the electronic component. There are various bandwidths available for data transfer. The analogue multiplexer has 4 outputs.