The electronic component is convenient to ship overseas because it is packed in a 16-TSSOP (0.173, 4.40mm Width). The advanced packaging method Tape & Reel (TR) provides high reliability. It is mounted in the position Surface Mount. 2:1 is the ratio between multiplexers and demultiplexers. The operating temperature is extended to around -40°C~125°C TA. The total number of terminations is 16. As a result of its 2 channels, this electronic component provides high-quality output. An 15V voltage supply should allow the electrical part to be turned on and run. A total of 16 pins are injected into the body of the electronic part. Based on SPDT switching circuits, these analog multiplexers work. Use ADG1236 to search for variants of the digital switches. The internal resistance of this digital multiplexer is 190Ohm. Datasheets for functions of 16 pins are available. Multiplexer or Switches is a typical switch device. normally, users should not supply switches with voltages higher than 16.5V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. A low voltage of 5V should be applied to the electronic component. This multiplexer would work with 170μA current. If you put voltage higher than 230μA on the digital multiplexer, damage may occur. For this multiplexer, dual supply voltage is feasible, but it should not exceed 16.5V. A dual power supply should have at least 5V voltage attached. A voltage of 12V can be used to operate the electronic component. There are various bandwidths available for data transfer. There are 4 outputs on the analogue multiplexer.