Shipping overseas is convenient due to the electrical component's packing in 28-TSSOP (0.173, 4.40mm Width). This high-reliability packaging method uses advanced packaging methods Tube. This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 8:1. Extended operating temperature around -40°C~125°C TA. Totally, there are 28 terminations. A 1 channel electronic part produces high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. It is injected into the electrical part body with 28 pins. The circuits in this analogue multiplexer number 2. Try searching for ADG1607 variants of the analog switch ic. There is 7.5Ohm internal resistance in this digital multiplexer. Please refer to the datasheets for 28 pins functions. It is normally recommended that users do not supply the multiplexer with voltages higher than 16V. It is recommended that the electrical component receives a voltage of 3.3V. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 8V. If you are using dual power supplies, you should attach at least 3.3V. It is integrated with DIFFERENTIAL MULTIPLEXER analog ICs. It is possible to use COMMON OUTPUT outputs on this digital multiplexer. The electrical part can be operated at 5V voltage levels. The electrical component supports 16 inputs. 38MHz-bandwidths can be used to transfer data between multiplexers. Drain to Source resistance for this electronic component is 7.5Ohm.