Shipping overseas is convenient with the electronic component packed in 20-TSSOP (0.173, 4.40mm Width). High reliability is ensured by the advanced packaging method Tape & Reel (TR). Mounted in Surface Mount is this multiplexer. 2:1 is the ratio of multiplexer to demultiplexer circuits. Extended operating temperature around -40°C~125°C TA. A total of 20 terminations have been recorded. Due to its 1 channels, the electrical component produces high-quality output. It is safe to turn on and run the electronic component with a 5V voltage supply. As part of its design, the 20 series is equipped with this electronic component. These analog multiplexers are built based on SPDT switching circuits. ADG1634 can be used to search for analog multiplexer variants. This digital multiplexer has 4.5Ohm internal resistance. The functions of 20 pins can be found in the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 16V should not normally be supplied to the switches. The analog switch ic is of the Dual, Single supply type and is cost-effective. There should be 3.3V voltage fed to the electrical part below 3.3V. This multiplexer would work with 300μA current. When the digital multiplexer is charged above 480μA, damage can occur. For this multiplexer, dual supply voltage is feasible, but it should not exceed 8V. You should attach at least 3.3V voltage if you are using dual power supply. A 4 input needs to be operated. This switch operates within the bandwidth of 103MHz. An output of 8 is provided by the digital multiplexer.