The electrical component comes in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) packaging, which makes it convenient to ship overseas. Advanced packaging method Tube is used to provide high reliability. Mounted in Surface Mount is this multiplexer. 2:1 is the ratio of multiplexer to demultiplexer circuits. Extended operating temperature around -40°C~125°C TA. Total terminations are 8. A high-quality output is provided by the electrical component's 1 channels. A 15V voltage supply should turn on and run the electronic component. A key feature of the 8 series is the inclusion of this electronic part as part of its design. Unlike digital switches, these are based on SPDT switching circuits. Using the ADG419 search parameter, you can discover variants of the switch. Internally, this switch multiplexer has a resistance of 35Ohm. For functions related to 8 pins, please refer to the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. Multiplexers should not be powered above 25V in normal situations. The digital multiplexer has a low cost Dual, Single supply. It is recommended that the electrical component receives a voltage of 5V. It would be sufficient to run this analogue multiplexer with 100pA current. When the digital multiplexer is charged above 1μA, damage can occur. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 22V. It is recommended that you attach at least 13.5V to your dual power supply. 12V operating voltages are supported by the electronic component. There is 25Ohm resistance between the Drain and Source on this part. The analog switch ics has 2 outputs.