Presented in 16-TSSOP (0.173, 4.40mm Width), this electrical component is convenient for overseas shipping. High reliability is ensured by the advanced packaging method Tube. In Surface Mount, you'll find this switch device. Multiplexers and demultiplexers have the same number of circuits 1:1. Extended operating temperature around -40°C~85°C TA. The total number of terminations is 16. This electronic part offers high-quality output due to its 4 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. There is an electrical component included in the 16 series. The analog switch ics are built using SPST - NC switching circuits. ADG411 can be used to search for analog multiplexer variants. The internal resistance of this digital multiplexer is 35Ohm. Datasheets for functions of 16 pins are available. The analogue multiplexer in this example is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 25V volts for the multiplexer. Digital switch that provides Dual, Single power at a cost-effective price. 5V is the lowest voltage that should be fed to the electronic electronic part. Put voltage above 1μA on the multiplexer to cause damage. There is no problem with using dual supply voltage, but it should not exceed 22V. A dual power supply should have at least 13.5V voltage attached. 12V operating voltages are supported by the electronic component. There is 100Ohm resistance between Drain and Source for this electronic part.