ADG419BR-REEL Overview

Shipping overseas is convenient with the electronic component packed in 8-SOIC (0.154, 3.90mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 2:1. Temperatures around -40°C~125°C TA are extended for operation. Total terminations are 8. High-quality output is provided by the electronic component's 1 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. The electronic part body is injected with 8 pins. A SPDT switching circuit is used to build these analog multiplexers. Try searching with ADG419 if you're looking for variants. There is 35Ohm internal resistance in this digital multiplexer. For functions related to 8 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 25V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. 5V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 100pA current would be sufficient. The analogue multiplexer may be damaged if voltage is greater than 1μA. If put voltage greater than 22V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 13.5V. 12V operating voltages are supported by the electronic component. The analogue multiplexer has 2 outputs.

ADG419BR-REEL Features

1 Channels
Switch Circuit: SPDT
100pA Supply Current

ADG419BR-REEL Applications

There are a lot of Analog Devices Inc.
ADG419BR-REEL Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems