The electronic part can be shipped overseas conveniently because it is packaged in 16-DIP (0.300, 7.62mm). A high level of reliability can be achieved through the use of an advanced packaging method Tube. In Through Hole, this analog switch is mounted. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operational temperature extended around -40°C~85°C TA. A total of 16 terminations have been recorded. A high-quality output is provided by the electrical component's 4 channels. An 15V voltage supply should allow the electrical part to be turned on and run. The electrical component body receives 16 pins. A SPST - NC switching circuit is used for these analog switches. Try searching with ADG431 to find analog multiplexer variants. The internal resistance of this digital multiplexer is 24Ohm. Datasheets for functions of 16 pins are available. The analogue multiplexer in this example is a typical Multiplexer or Switches. In a normalsituation, users should not supply the switches with voltage higher than 25V. The digital multiplexer has a low cost Dual, Single supply. 5V should be the lowest voltage fed to the electronic component. The switch multiplexer may be damaged if it is exposed to voltage greater than 100nA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 22V. If you are using dual power supplies, you should attach at least 13.5V. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. The electrical part can be operated at 12V voltage levels. Drain to Source resistance for this electronic component is 17mOhm.