Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Multiplexers like this are mounted in the Surface Mount position. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. The operating temperature is extended to around -40°C~105°C TA. In total, there have been 16 terminations. A high-quality output is provided by the electrical component's 1 channels. In the case of a voltage supply of 5V volts, the electrical part can be powered up and run. A total of 16 pins are injected into the body of the electronic part. Unlike digital switches, these are based on SPST - NO/NC switching circuits. Search with ADG4613 if you are looking for analog multiplexer variants. An switch multiplexer with 5.1Ohm internal resistance has a value of 5.1Ohm. You can find the functions of the 16 pins in the datasheets. It is a typical Multiplexer or Switches analog multiplexer. In a normalsituation, users should not supply the switches with voltage higher than 12V. An effective Dual, Single supply digital multiplexer. A low voltage of 3V should be applied to the electronic component. A voltage higher than 140μA may cause damage to the switch multiplexer. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 5.5V. If you are using dual power supplies, you should attach at least 3V. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. In order to operate the 4 inputs, there are several steps to follow. It is possible to transfer data over a 250MHz-bandwidth.