ADG512BNZ Overview

Shipping overseas is convenient with the electronic component packed in 16-DIP (0.300, 7.62mm). High reliability is provided by advanced packaging method Tube. In Through Hole, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 1:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 16. High-quality output is provided by the electronic component's 4 channels. If the voltage supply is 5V volts, the electrical component should be turned on and run. The electronic part body is injected with 16 pins. A SPST - NO switching circuit is used to build these analog multiplexers. Try searching with ADG512 if you're looking for variants. There is 30Ohm internal resistance in this digital multiplexer. For functions related to 16 pins, please refer to the datasheets. Theswitch device is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. 4.5V should be the lowest voltage fed to the electronic component. The analogue multiplexer may be damaged if voltage is greater than 1μA. If put voltage greater than 5.5V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 4.5V. The analog switch ic utilizes SEPARATE OUTPUT outputs in total. 5V operating voltages are supported by the electronic component. Drain to Source resistance is 75Ohm.

ADG512BNZ Features

4 Channels
Switch Circuit: SPST - NO
Drain-to-Source resistance: 75Ohm

ADG512BNZ Applications

There are a lot of Analog Devices Inc.
ADG512BNZ Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems