This electronic part is conveniently packaged in 16-WQFN Exposed Pad, CSP, making it easy to ship abroad. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. This analog switch is mounted in Surface Mount. 4:1 is the ratio of multiplexer to demultiplexer circuits. The operating temperature is extended to around -40°C~125°C TA. Totally, there are 16 terminations. The electronic part delivers high-quality output through its 4 channels. An injection of 16 pins is performed into the body of the electrical component. On the other hand, analog switches can be constructed using SP4T switching circuits. There are 2 circuits in this multiplexer. Try searching for ADG5209 variants of the analog switch ic. As far as internal resistance is concerned, it has 160Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. It is generally not recommended to supply a voltage higher than 40V to the switch device in normal circumstances. A cost-effective Dual, Single supply type analogue multiplexer. The lowest voltage the electronic part should receive is 9V. The analogue multiplexer could operate on 80μA current. If put voltage greater than 130μA on the device, damage may be caused to the analogue multiplexer. There is no problem with using dual supply voltage, but it should not exceed 22V. The voltage should be at least 9V if you are using dual power supplies. A voltage of 36V can be used to operate the electronic component. There are 8 inputs to be operated. It is possible to transfer data over a 133MHz-bandwidth.