ADG5408BCPZ-REEL7 Overview

Presented in 16-WQFN Exposed Pad, CSP, this electrical component is convenient for overseas shipping. This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). In Surface Mount, this analog switch is mounted. 8:1 is the ratio of multiplexer to demultiplexer circuits. Extended operating temperature around -40°C~125°C TA. 16 terminations have been made so far. High-quality output is provided by the electronic component's 8 channels. A 15V voltage supply should turn on and run the electronic component. This electrical component is included in the 16 series of products. This multiplexer is composed of 1 circuits. Try searching for ADG5408 variants of the analog switch ic. The internal resistance of this digital multiplexer is 14Ohm. To find out what the 16 pins do, please refer to the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. In normalcircumstances, users should not exceed 40V volts for the multiplexer. There should be 9V voltage fed to the electrical part below 9V. Put voltage above 80μA on the multiplexer to cause damage. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 22V. With dual power supplies, you should attach at least 9V. There is an integrated analog IC SINGLE-ENDED MULTIPLEXER in the module. In 50MHz-bandwidths, data can be transferred. A Drain to Source resistance of 16Ohm is shown for this electronic part.

ADG5408BCPZ-REEL7 Features

8 Channels
Bandwidth: 50MHz
Drain-to-Source resistance: 16Ohm

ADG5408BCPZ-REEL7 Applications

There are a lot of Analog Devices Inc. ADG5408BCPZ-REEL7 Analog Switches & Multiplexers ICs applications.

• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• ISDN NT1/TA
• Multi-Line E1 Interface Cards
• Channelized and Unchannelized DS3 applications
• High speed data transmission line cards
• Cable Modem
• E1 Multiplexer
• Microprocessor controlled systems
• Remote Powered Equipment
• Automotive applications