ADG5408BRUZ Overview

The electrical component comes in 16-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 8:1 represents the number of circuits. Operating temperature around -40°C~125°C TA extended. In total, 16 terminations have occurred. A electrical component with 8 channels is capable of high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. Into the electrical component body are injected 16 pins. Circuits number 1 make up this analogue multiplexer. Look for analog switch ic variants by searching with ADG5408. A 14Ohm internal resistance characterizes this multiplexer. The datasheets for the 16 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 40V. It is recommended to use 9V as the lowest voltage for the electrical part. A voltage higher than 80μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 22VFor dual power supplies, a voltage of at least 9V should be attached. Integrated with an analog IC SINGLE-ENDED MULTIPLEXER. Among the inputs that can be operated are the 8 inputs. It is possible to transfer data over a 50MHz-bandwidth. There is 22Ohm Drain to Source resistance on this electronic part.

ADG5408BRUZ Features

8 Channels
Bandwidth: 50MHz
Drain-to-Source resistance: 22Ohm

ADG5408BRUZ Applications

There are a lot of Analog Devices Inc.
ADG5408BRUZ Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)