As the electronic part is packed in 16-TSSOP (0.173, 4.40mm Width), international shipping is convenient. This packaging method provides high reliability because it uses advanced packaging techniques. Multiplexers like this are mounted in the Surface Mount position. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Temperatures around -40°C~125°C TA are extended for operation. In total, there are 16 terminations. Due to its 1 channels, the electrical component produces high-quality output. Turning on and running the electrical part should be easy with a 15V voltage supply. Electronic part bodies are injected with 16 pins. On the other hand, analog switches can be constructed using SPST - NO/NC switching circuits. The multiplexer consists of 4 circuits. Try searching for the analog switch ic with ADG5413 if you are looking for variants. A 11.5Ohm internal resistance characterizes this multiplexer. The functions of 16 pins can be found in the datasheets. An abnormal situation would be for the switch device to be supplied with a voltage greater than 40V. Dual, Single supply type digital switch with a low cost. There should be 9V voltage fed to the electrical part below 9V. The switch multiplexer may be damaged if it is exposed to voltage greater than 55μA. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 22V. If you are using dual power supplies, you should attach at least 9V. It is possible to transfer data over a 160MHz-bandwidth.