The electrical component comes in 16-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. Advanced packaging method Tape & Reel (TR) is used to provide high reliability. Multiplexers like this are mounted in the Surface Mount position. Multiplexers and demultiplexers have a ratio of 1:1. The operating temperature is extended to around -40°C~125°C TA. The total number of terminations is 16. Due to its 4 channels, the electrical component produces high-quality output. Powered by a 5V voltage supply, the electrical part should be switched on and run. This electrical component is included in the 16 series of products. Circuits based on SPST - NC switching are used to construct these analog switch ics. Using the ADG611 search parameter, you can discover variants of the switch. As far as internal resistance is concerned, it has 115Ohm. For details about the functions of 16 pins, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 5.5V. Digital switch that provides Dual, Single power at a cost-effective price. There should be 2.7V voltage fed to the electrical part below 2.7V. The switch device would be able to operate with 1nA current. A voltage higher than 1μA may cause damage to the switch multiplexer. Despite this switch's dual supply capability, its voltage should not exceed 5.5V. It is recommended that you attach at least 2.7V to your dual power supply. The data can be transferred over a wide range of bandwidths, called 680MHz bandwidths.