ADG619BRM-REEL Overview

As the electronic part is packed in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), international shipping is convenient. The advanced packaging method Tape & Reel (TR) provides high reliability. There is an analog multiplexer mounted in position Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Operation at a temperature around -40°C~85°C TA. Total terminations are 8. By its 1 channels, the electronic component provides high-quality output. With a 5V voltage supply, the electrical component should be turned on and run. An electrical component of this type can be found in the 8 series. Circuits based on SPDT switching are used to construct these analog switch ics. Search with ADG619 if you are looking for analog multiplexer variants. The internal resistance of this digital multiplexer is 6.5Ohm. To find out what the 8 pins do, please refer to the datasheets. Multiplexer or Switches is a typical switch device. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. 2.7V should be the lowest voltage fed to the electronic component. For this multiplexer, dual supply voltage is feasible, but it should not exceed 5.5V. It is recommended that you attach at least 2.7V to your dual power supply. An output of 2 is provided by the digital multiplexer.

ADG619BRM-REEL Features

1 Channels
Switch Circuit: SPDT
-3db Bandwidth: 190MHz

ADG619BRM-REEL Applications

There are a lot of Analog Devices Inc. ADG619BRM-REEL Analog Switches & Multiplexers ICs applications.

• Communication systems
• Avionics test equipment
• Industrial control systems
• Battery-powered systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• New designs requiring multiplexer functions
• Isolation
• 65 V DACs
• Modems
• MP3 players