Presented in SOT-23-8, this electrical component is convenient for overseas shipping. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. Surface Mount is where this multiplexer is located. Multiplexer and demultiplexer circuits have a number 2:1. Around -55°C~125°C TA is the extended operating temperature. 8 terminations have been made so far. As a result of its 1 channels, this electronic component provides high-quality output. An 5V voltage supply should allow the electrical part to be turned on and run. An electrical component like this is included in the 8 series. SPDT switching circuits are used in these analog switch ics. Try searching with ADG619 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 6.5Ohm. For functions related to 8 pins, please refer to the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. Dual, Single supply type digital switch with a low cost. 2.7V is the lowest voltage the electrical component should receive. The analogue multiplexer could operate on 1nA current. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 5.5V. If you are using a dual power supply, you should attach at least 2.7V. It is possible to operate 1 inputs. 190MHz bandwidths enable data to be transferred. The Drain to Source resistance of this electronic component is 6.5Ohm. The analog switch ics includes 2 outputs.