The electrical component comes in 8-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. In order to provide high reliability, an advanced packaging method Tube is used. The multiplexer is located in Surface Mount. 1:1 is the ratio of multiplexer to demultiplexer circuits. Temperatures around -40°C~85°C TA are extended for operation. 8 terminations have been made so far. A 1 channel electronic part produces high-quality output. Powered by a 3.3V voltage supply, the electrical part should be switched on and run. This electrical component is included in the 8 series of products. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Search with TS12A4515 if you are looking for analog multiplexer variants. A 20Ohm internal resistance characterizes this multiplexer. Datasheets for functions of 8 pins are available. There is a standard Multiplexer or Switches analogue multiplexer here. Users shouldn't supply more than 12V voltage to the switch device. A cost-effective Single supply type analogue multiplexer. In order for the electronic part to function properly, the lowest voltage should be 2V. An operating current of 50nA would be sufficient for this switch device. A voltage of 2.7V~12V is required for this switch device, which drains from a single voltage source. It may damage the digital multiplexer if the voltage is higher than 50nA. There are SEPARATE OUTPUT outputs on this analog switch ic. Among the inputs that can be operated are the 1 inputs. This switch operates within the bandwidth of 475MHz.