The electronic component is convenient to ship overseas because it is packed in a 14-TSSOP (0.173, 4.40mm Width). To ensure high reliability, a new packaging method Tube is used. A switch device like this is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Operating temperature extended to -40°C~125°C TA. Total terminations are 14. The electronic part delivers high-quality output through its 2 channels. Turning on and running the electrical part should be easy with a 5V voltage supply. As part of its design, the 14 series is equipped with this electronic component. The analog switch ics are built using SPDT switching circuits. Look for analog switch ic variants by searching with ADG636. Analog switches have 115Ohm internal resistance. You can find the functions of the 14 pins in the datasheets. A analogue multiplexer of this type is a Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. Digital switch that provides Dual, Single power at a cost-effective price. 2.7V is the lowest voltage the electrical component should receive. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 5.5V. The voltage should be at least 2.7V if you are using dual power supplies. A 610MHz-bandwidth can be used for data transfer. A Drain to Source resistance of 85Ohm is shown for this electronic part. The analogue multiplexer has 4 outputs.