Packed in 16-TSSOP (0.173, 4.40mm Width), the electronic component is convenient for shipping overseas. High reliability is provided by advanced packaging method Tube. A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 4:1. An extended operating temperature of -40°C~125°C TA degrees Celsius. A total of 16 terminations have been recorded. The electronic part delivers high-quality output through its 4 channels. If the voltage supply is 5V volts, the electrical component should be turned on and run. The electronic part body is injected with 16 pins. Multiplexers built on a SP4T switching circuit are built. It consists of 2 circuits. If you are looking for variants of the digital switch, trying search with ADG659. It has an internal resistance of 45Ohm. To find out what the 16 pins do, please refer to the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. Users shouldn't supply more than 12V voltage to the switch device. The lowest voltage fed to the electronic component should be 2V. If put voltage greater than 6V on the multiplexer, damage may be caused to the device. The voltage should be at least 2V if you are using dual power supplies. Integrated with an analog IC DIFFERENTIAL MULTIPLEXER. A voltage of 5V can be used to operate the electronic component. In order to operate the 8 inputs, there are several steps to follow. 400MHz bandwidths enable data to be transferred. Resistivity from Drain to Source is 45Ohm for this electronic part.