ADG884BRMZ-REEL7 Overview

Shipping overseas is convenient due to the electrical component's packing in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width). In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. It is mounted in the position Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:1. Operating temperature extended to -40°C~85°C TA. In total, there are 10 terminations. The electronic part delivers high-quality output through its 2 channels. An 2.7V voltage supply should allow the electrical part to be turned on and run. This electrical component is included in the 10 series of products. Multiplexers built on a SPDT switching circuit are built. ADG884 can be used to search for analog multiplexer variants. An switch multiplexer with 370mOhm internal resistance has a value of 370mOhm. For details about the functions of 10 pins, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. A voltage higher than 5.5V should not normally be supplied to the switches. Single supply type digital switch with a low cost. 1.8V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 3nA current would be sufficient. Analogue multiplexers require a 1.8V~5.5V voltage to drain from a single voltage supply. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. A AUDIO/VIDEO SWITCH analog IC is integrated into the board. Operating voltages of 5.5V are compatible with the electrical part. This switch operates within the bandwidth of 18MHz. 4 outputs are included in the analogue multiplexer.

ADG884BRMZ-REEL7 Features

2 Channels
Switch Circuit: SPDT
3nA Supply Current
Bandwidth: 18MHz

ADG884BRMZ-REEL7 Applications

There are a lot of Analog Devices Inc. ADG884BRMZ-REEL7 Analog Switches & Multiplexers ICs applications.

• SONET
• PDH Multiplexers
• Isolation
• E1 Multiplexer
• DVD-R
• ATM
• Ultrasound
• Remote wireless modules
• PDAs
• Data switching