ADG701BRMZ-REEL7 Overview

As the electronic part is packed in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to -40°C~85°C TA. Total terminations are 8. The electronic part provides high-quality output because it has 1 channels. Powered by a 3V voltage supply, the electrical part should be switched on and run. The electrical component body receives 8 pins. Circuits based on SPST - NO switching are used to construct these analog switch ics. Try searching with ADG701 to find analog multiplexer variants. An switch multiplexer with 3Ohm internal resistance has a value of 3Ohm. Datasheets for 8 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 1.8V. An operating current of 1nA would be sufficient for this switch device. Using a single voltage supply, this switch device consumes 1.8V~5V volts. When the digital multiplexer is charged above 1μA, damage can occur. There are 200MHz bandwidths for data transfer.

ADG701BRMZ-REEL7 Features

1 Channels
Switch Circuit: SPST - NO
1nA Supply Current
Bandwidth: 200MHz

ADG701BRMZ-REEL7 Applications

There are a lot of Analog Devices Inc.
ADG701BRMZ-REEL7 Analog Switches & Multiplexers ICs applications.

• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement