ADG704BRMZ Overview

The electronic part can be shipped overseas conveniently because it is packaged in 10-TFSOP, 10-MSOP (0.118, 3.00mm Width). High reliability is provided by advanced packaging method Tube. Surface Mount is where this multiplexer is located. The ratio between the number of multiplexer and demultiplexer circuits is 4:1. Operating temperature around -40°C~85°C TA extended. 10 terminations have been made so far. This electronic part offers high-quality output due to its 4 channels. An 3V voltage supply should allow the electrical part to be turned on and run. A key feature of the 10 series is the inclusion of this electronic part as part of its design. On the other hand, analog switches can be constructed using SP4T switching circuits. Circuits number 1 make up this analogue multiplexer. Use ADG704 to search for variants of the digital switches. Analog switches have 4Ohm internal resistance. Please refer to the datasheets for 10 pins functions. A analogue multiplexer of this type is a Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. The lowest voltage the electronic part should receive is 1.8V. In order to operate this switch device, it would need a current of 1nA. The voltage required by this switch device is 1.8V~5V, draining from a single voltage supply. When the digital multiplexer is charged above 1μA, damage can occur. There is an integrated analog IC SINGLE-ENDED MULTIPLEXER in the module. The electrical part can be operated at 5V voltage levels. The transfer of data can be performed over 200MHz bandwidths. Drain to Source resistance is 35Ohm.

ADG704BRMZ Features

4 Channels
Switch Circuit: SP4T
1nA Supply Current
Bandwidth: 200MHz
Drain-to-Source resistance: 35Ohm

ADG704BRMZ Applications

There are a lot of Analog Devices Inc. ADG704BRMZ Analog Switches & Multiplexers ICs applications.

• Switching Systems

• Microprocessor controlled systems

• SONET/SDH ADM

• Power routing

• ATM

• FTTH

• PDH Multiplexers

• Precision instrumentation

• Multi-Line E1 Interface Cards

• Existing multiplexer applications (both fault-protected and nonfault-protected)