Shipping overseas is convenient with the electronic component packed in 16-TSSOP (0.173, 4.40mm Width). In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. In Surface Mount, this analog switch is mounted. 1:1 is the number of circuits in the multiplexer and demultiplexer. Extended operating temperature around -40°C~85°C TA. 16 terminations have been made so far. By its 1 channels, the electronic component provides high-quality output. It is safe to turn on and run the electronic component with a 3V voltage supply. It is injected into the electrical part body with 16 pins. Multiplexers built on a SPST - NC switching circuit are built. It consists of 4 circuits. ADG711 can be used to search for analog multiplexer variants. As far as internal resistance is concerned, it has 4Ohm. For functions related to 16 pins, please refer to the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. In order for the electronic part to function properly, the lowest voltage should be 1.8V. Using only a single voltage supply, this analog switch requires 1.8V~5.5V voltage. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. Additional features of the electronic component include: CAN ALSO OPERATE WITH 5 V SUPPLY.
ADG711BRU-REEL Features
1 Channels Switch Circuit: SPST - NC -3db Bandwidth: 200MHz Additional Features: CAN ALSO OPERATE WITH 5 V SUPPLY
ADG711BRU-REEL Applications
There are a lot of Analog Devices Inc. ADG711BRU-REEL Analog Switches & Multiplexers ICs applications.
Remote wireless modules
Multi-Line E1 Interface Cards
Avionics and Military Systems
Video switching
PBXs
Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads