ADG711BRUZ Overview

As the electronic part is packed in 16-TSSOP (0.173, 4.40mm Width), international shipping is convenient. The advanced packaging method Tube provides high reliability. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 1:1. Operating temperature around -40°C~85°C TA extended. Total terminations are 16. Due to its 4 channels, the electrical component produces high-quality output. An 3V voltage supply should allow the electrical part to be turned on and run. It is injected into the electrical part body with 16 pins. These analog multiplexers are built based on SPST - NO switching circuits. ADG711 can be used to search for analog multiplexer variants. A 4Ohm internal resistance characterizes this multiplexer. For details about the functions of 16 pins, please refer to the datasheets. Multiplexer or Switches is a typical switch device. Users shouldn't supply more than 5.5V voltage to the switch device. There should be 1.8V voltage fed to the electrical part below 1.8V. The switch device would be able to operate with 1nA current. Using only a single voltage supply, this analog switch requires 1.8V~5.5V voltage. When the digital multiplexer is charged above 1μA, damage can occur. A 200MHz-bandwidth can be used for data transfer. Additional features of the electronic component include: CAN ALSO OPERATE WITH 5 V SUPPLY. There is 2.5Ohm Drain to Source resistance on this electronic part.

ADG711BRUZ Features

4 Channels
Switch Circuit: SPST - NO
1nA Supply Current
Bandwidth: 200MHz
Additional Features: CAN ALSO OPERATE WITH 5 V SUPPLY
Drain-to-Source resistance: 2.5Ohm

ADG711BRUZ Applications

There are a lot of Analog Devices Inc. ADG711BRUZ Analog Switches & Multiplexers ICs applications.

• Transmit
• Data switching
• Battery Powered Systems
• Relay replacements
• E1 Multiplexer
• Cross Connects
• Digital access cross connects
• Cable Telephony – NIU, Set-Top Box, Home Side Box
• Multi-Line E1 Interface Cards
• Video signal routing