ADG711BRZ-REEL Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-SOIC (0.154, 3.90mm Width). In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. There is an analog multiplexer mounted in position Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Around -40°C~85°C TA is the extended operating temperature. In total, there are 16 terminations. This electronic part offers high-quality output due to its 4 channels. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. There are 16 pins injected into the electronic part body. The analog switch ics are built using SPST - NC switching circuits. Search with ADG711 if you are looking for analog multiplexer variants. It has an internal resistance of 4Ohm. The functions of 16 pins can be found in the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. Single supply type digital switch with a low cost. 1.8V is the lowest voltage that should be fed to the electronic electronic part. In order to operate this switch device, it would need a current of 1nA. A voltage of 1.8V~5.5V is required to drain this analog switch from a single voltage supply. A digital multiplexer may suffer damage if voltage is applied above 1μA. There are SEPARATE OUTPUT outputs on this analog switch ic. The transfer of data can be performed over 200MHz bandwidths. There is also CAN ALSO OPERATE WITH 5 V SUPPLY to look out for in this electronic part.

ADG711BRZ-REEL Features

4 Channels
Switch Circuit: SPST - NC
1nA Supply Current
Bandwidth: 200MHz
Additional Features: CAN ALSO OPERATE WITH 5 V SUPPLY

ADG711BRZ-REEL Applications

There are a lot of Analog Devices Inc.
ADG711BRZ-REEL Analog Switches & Multiplexers ICs applications.

• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems