Presented in 16-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. To ensure high reliability, a new packaging method Tube is used. Mounted in Through Hole is this multiplexer. There is 4:1 ratio between the number of multiplexers and demultiplexers. Increasing operating temperature to around -55°C~125°C TA. Totally, there are 16 terminations. This electronic part offers high-quality output due to its 8 channels. Turning on and running the electrical part should be easy with a 4.5V voltage supply. A total of 16 pins are injected into the electrical part body. On the other hand, analog switches can be constructed using SP4T switching circuits. Circuits number 2 make up this analogue multiplexer. Try searching for 74HC4052 variants of the analog switch ic. There is 130Ohm internal resistance in this digital multiplexer. The functions of 16 pins can be found in the datasheets. In this analog multiplexer, the value is Multiplexer or Switches. Multiplexers should not be powered above 6V in normal situations. Dual, Single supply type digital switch with a low cost. It is recommended to use 2V as the lowest voltage for the electrical part. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 5V. It is recommended that you attach at least 1V to your dual power supply. It is integrated with DIFFERENTIAL MULTIPLEXER analog ICs. The digital multiplexer has COMMON OUTPUT outputs that can be used. The data can be transferred over a wide range of bandwidths, called 185MHz bandwidths. It has a Drain to Source resistance of 80Ohm ohms. It is able to conduct in a 4-bit way.