The electrical component comes in 16-SOIC (0.154, 3.90mm Width) packaging, which makes it convenient to ship overseas. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. 1:1 is the ratio of multiplexer to demultiplexer circuits. Temperatures around -40°C~85°C TA are extended for operation. A total of 16 terminations have been recorded. A 4 channel electronic part produces high-quality output. An 3V voltage supply should allow the electrical part to be turned on and run. An injection of 16 pins is performed into the body of the electrical component. A SPST - NO/NC switching circuit is used to build these analog multiplexers. Search with ADG713 if you are looking for analog multiplexer variants. A 4Ohm internal resistance characterizes this multiplexer. The functions of 16 pins can be found in the datasheets. It is a typical Multiplexer or Switches analog multiplexer. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. A analog switch ic that has a cost-effective Single supply type. In order for the electronic part to function properly, the lowest voltage should be 1.8V. For this multiplexer to operate, 1nA current would be sufficient. Using a single voltage supply, this switch device consumes 1.8V~5.5V volts. A digital multiplexer may suffer damage if voltage is applied above 1μA. This electrical component also includes additional features such as CAN ALSO OPERATE WITH 5 V SUPPLY.
ADG713BR-REEL Features
4 Channels Switch Circuit: SPST - NO/NC 1nA Supply Current -3db Bandwidth: 200MHz Additional Features: CAN ALSO OPERATE WITH 5 V SUPPLY
ADG713BR-REEL Applications
There are a lot of Analog Devices Inc. ADG713BR-REEL Analog Switches & Multiplexers ICs applications.