ADG802BRM-REEL7 Overview

The electronic part can be shipped overseas conveniently because it is packaged in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Around -40°C~125°C TA is the extended operating temperature. Total terminations are 8. Due to its 1 channels, the electrical component produces high-quality output. If the voltage supply is 3V volts, the electrical component should be turned on and run. It is injected into the electrical part body with 8 pins. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Search with ADG802 if you are looking for analog multiplexer variants. The internal resistance of this digital multiplexer is 300mOhm. You can find the functions of the 8 pins in the datasheets. Theswitch device is a typical Multiplexer or Switches. Users should never supply a voltage higher than 5.5V to a switch device. The analog switch ic is of the Single supply type and is cost-effective. A low voltage of 1.8V should be applied to the electronic component. The voltage required by this switch device is 1.8V~5.5V, draining from a single voltage supply. If you put voltage higher than 1μA on the digital multiplexer, damage may occur.

ADG802BRM-REEL7 Features

1 Channels
Switch Circuit: SPST - NC
-3db Bandwidth: 12MHz

ADG802BRM-REEL7 Applications

There are a lot of Analog Devices Inc. ADG802BRM-REEL7 Analog Switches & Multiplexers ICs applications.

• PDAs
• Modems
• Cable Modem
• Battery Powered Systems
• Private Branch Exchange (PBX)
• Voice over IP/DSL – Integrated Access Devices, Smart
• Data switching
• PBXs
• Isolation
• E1 Network Equipment