ADG715BRUZ-REEL Overview

Shipping overseas is convenient with the electronic component packed in 24-TSSOP (0.173, 4.40mm Width). High reliability is provided by advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. Multiplexers and demultiplexers have a ratio of 1:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 24. High-quality output is provided by the electronic component's 8 channels. If the voltage supply is 2.5V volts, the electrical component should be turned on and run. The electronic part body is injected with 24 pins. A SPST - NO switching circuit is used to build these analog multiplexers. Try searching with ADG715 if you're looking for variants. There is 4.5Ohm internal resistance in this digital multiplexer. For functions related to 24 pins, please refer to the datasheets. A voltage higher than 5.5V should not normally be supplied to the switches. Analogue multiplexers of the Dual, Single supply type that are cost-effective. 2.7V should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 10μA current would be sufficient. The analogue multiplexer may be damaged if voltage is greater than 20μA. If put voltage greater than 2.75V on the multiplexer, damage may be caused to the device. If you are using dual power supplies, you should attach at least 2.25V. A 155MHz-bandwidth can be used for data transfer.

ADG715BRUZ-REEL Features

8 Channels
Switch Circuit: SPST - NO
10μA Supply Current
Bandwidth: 155MHz

ADG715BRUZ-REEL Applications

There are a lot of Analog Devices Inc.
ADG715BRUZ-REEL Analog Switches & Multiplexers ICs applications.

• Transmit
• Low-Voltage
• Isolation
• Medical
• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems