ADG719BRM-REEL7 Overview

This electronic part is conveniently packaged in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), making it easy to ship abroad. High reliability is achieved by using advanced packaging method Tape & Reel (TR). A switch device like this is mounted in Surface Mount. There is 2:1 ratio between the number of multiplexers and demultiplexers. Operational temperature extended around -40°C~125°C TA. Total terminations are 8. A high-quality output is provided by the electrical component's 1 channels. With a 3V voltage supply, the electrical component should be turned on and run. 8 pins are injected to the electronic part body. SPDT switching circuits are used in these analog switch ics. Try searching for ADG719 variants of the analog switch ic. An switch multiplexer with 4Ohm internal resistance has a value of 4Ohm. The functions of 8 pins can be found in the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. Analog switch ics with Single supply type are cost-effective. 1.8V should be the lowest voltage fed to the electronic component. The analogue multiplexer could operate on 1nA current. This analogue multiplexer requires a voltage of 1.8V~5.5V when it drains from a single voltage supply. Put voltage above 1μA on the multiplexer to cause damage. This switch operates within the bandwidth of 200MHz. 2 outputs are included in the analogue multiplexer.

ADG719BRM-REEL7 Features

1 Channels
Switch Circuit: SPDT
1nA Supply Current
Bandwidth: 200MHz

ADG719BRM-REEL7 Applications

There are a lot of Analog Devices Inc. ADG719BRM-REEL7 Analog Switches & Multiplexers ICs applications.

• Sample hold systems
• DSLAMs
• Multi-Line E1 Interface Cards
• Data Acquisition Systems
• SDH/SONET multiplexers
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• Cable PC
• Precision test equipment
• PBX interfaces
• Cross Connects