Shipping overseas is convenient due to the electrical component's packing in 16-TSSOP (0.173, 4.40mm Width). This high-reliability packaging method uses advanced packaging methods Tube. There is an analog multiplexer mounted in position Surface Mount. 8:1 is the ratio between multiplexers and demultiplexers. The operating temperature is extended to around -40°C~85°C TA. The total number of terminations is 16. As a result of its 8 channels, this electronic component provides high-quality output. An 3V voltage supply should allow the electrical part to be turned on and run. This electrical component is included in the 16 series of products. It consists of 1 circuits. Search with ADG728 if you are looking for analog multiplexer variants. There is 4.5Ohm internal resistance in this digital multiplexer. To find out what the 16 pins do, please refer to the datasheets. It is a typical Multiplexers or Switches analog multiplexer. It is normally recommended that users do not supply the multiplexer with voltages higher than 5.5V. It is recommended that the electrical component receives a voltage of 2.7V. This digital switch can be operated with a current of 10μA. This analogue multiplexer requires a voltage of 2.7V~5.5V when it drains from a single voltage supply. If put voltage greater than 20μA on the device, damage may be caused to the analogue multiplexer. Integrated with AUDIO/VIDEO SWITCH analog IC. A 65MHz-bandwidth can be used for data transfer. Resistivity from Drain to Source is 2.5Ohm for this electronic part. The switch device is capable of conducting in a 8-bit mode.