ADG741BKSZ-REEL7 Overview

The electronic component is convenient to ship overseas because it is packed in a 6-TSSOP, SC-88, SOT-363. High reliability is provided by advanced packaging method Tape & Reel (TR). A switch device like this is mounted in Surface Mount. Multiplexer and demultiplexer circuits have a number 1:1. Temperatures around -40°C~85°C TA are extended for operation. Total terminations are 6. This electronic part offers high-quality output due to its 1 channels. An 3V voltage supply should allow the electrical part to be turned on and run. As part of the design of the 6 series, this electronic part has been incorporated into the system. Multiplexers built on a SPST - NO switching circuit are built. Try searching for the analog switch ic with ADG741 if you are looking for variants. There is 3Ohm internal resistance in this digital multiplexer. Please refer to the datasheets for 6 pins functions. There is a standard Multiplexer or Switches analogue multiplexer here. In a normalsituation, users should not supply the switches with voltage higher than 5.5V. It is recommended to use 1.8V as the lowest voltage for the electrical part. A voltage of 1.8V~5.5V is required for this switch device, which drains from a single voltage source. The analogue multiplexer may be damaged if voltage is greater than 1μA. 200MHz bandwidths enable data to be transferred. Check out the electrical component's additional features, such as the following: CAN ALSO OPERATE WITH 5 VOLT SUPPLY.

ADG741BKSZ-REEL7 Features

1 Channels
Switch Circuit: SPST - NO
Bandwidth: 200MHz
Additional Features: CAN ALSO OPERATE WITH 5 VOLT SUPPLY

ADG741BKSZ-REEL7 Applications

There are a lot of Analog Devices Inc. ADG741BKSZ-REEL7 Analog Switches & Multiplexers ICs applications.

• Medical
• USB 1.1 signal switching circuits
• ATM
• Communication systems
• DSUs
• Low-Voltage
• PDAs
• Communications systems
• Mechanical reed relay replacement
• Switching Systems